The Clean Exterior Blog

What to Put on Concrete After Pressure Washing

The wash is done, the driveway is bright — now what? What you put on concrete after pressure washing (and what you deliberately don't) decides whether it stays that way for two years or two months.

Option 1: Nothing — and when that is fine

Clean concrete with no coating is a perfectly good end state. It will re-dirty at the normal rate, and you wash again in a year or two. If the slab is old, cracked, or headed for replacement, this is the right call — spend nothing protecting concrete that is leaving.

Option 2: Sealer — the one that earns its money

A penetrating concrete sealer is the real answer for a sound Des Moines driveway. It soaks in (it is not a surface film, so it never peels), blocks water and salt absorption, and makes future stains sit on top where they can be rinsed off. The rules:

  • Dry first. Concrete needs at least 24–48 hours of dry weather after washing before sealer goes on. Seal damp concrete and you have sealed the water in.
  • Penetrating beats film-forming in Iowa. Films peel under freeze-thaw and tire heat; penetrating sealers wear gradually and can be reapplied without stripping.
  • Every 3–5 years is the reapplication cycle for a driveway that gets real winter use.

What not to put on it

  • Paint. Peels under tires within a year and becomes a stripping project.
  • Cheap big-box "waterproofer" over dirty or damp concrete — same peel, faster.
  • Anything, the same day as the wash. Wet concrete is the number one cause of every coating failure we get called about.

The sequence, start to finish

Clean → dry 24–48 hours → seal if the slab is sound → enjoy it through winter. We do the cleaning and the sealing as one booking with the dry-time built into the schedule — one quote covers both.

Ready to see your place look new again?

Send us a couple of photos and we'll text you a firm quote — no pressure, no obligation, no pushy sales visit.

Get My Free Quote
Talk to Us HereFree Quote